Using The Download Utility - FutureLogic PSA-66-ST Instructions Manual

6. Remove the printer from the machine.
7. Slide the printer into the standalone Stationary Module which will be connected to the PC.
8. Connect the black end of the Ribbon Cable to the rear Daughter Board of the Stationary
Module.
2.2

Using the Download Utility

Verify that you have installed the FutureLogic, Inc. Download Utility. You can acquire this
software from the FutureLogic, Inc. Web site (http://www.futurelogic-inc.com) or CD-ROM.
Note: The main window of the Download Utility displays a tab marked Auto Download.
Additional tabs for each communications port you select on the Auto Download
Preferences dialog display as well.
When the Download Utility detects a printer connected to a communications port, the
tab for that port displays "Printer Found." If not printer is detected, the tab for that port
displays "??No Printer??".
To change the firmware on the PSA-66-ST printer:
1. Access the Download Utility.
Toolbar
Buttons
Tabs
Copyright © 2004 FutureLogic, Inc. All Rights Reserved.
Figure 2-4 Press the Release Lever
Figure 2-5 Download Utility – Main Window
PSA-66-ST
Firmware Download Utility Instructions
PUBN Page 4 of 22 11/30/2004
PUBN-000015 REV.A
Release Lever