FutureLogic PSA-66-ST Instructions Manual page 20

10. Power down the PSA-66 4-Station Stand.
11. Double-check the results by printing a self test ticket.
a. Pull the printer out of the Stationary Module of the PSA-66 4-Station Stand until the
FEED button is visible.
b. Press and hold the FEED button on the printer while powering up the PSA-66 4-Station
Stand.
c. Continue to hold the FEED button until the ticket starts to print, then release.
d. Repeat steps 11a through 11c for each printer in the PSA-66 4-Station Stand.
This self test ticket will show the firmware version that is loaded. Double-check this against
the version printed on the prior test ticket (step 8). Also, check the library inventory. There
should be entries for Templates, Print Regions, and System Resources.
Copyright © 2004 FutureLogic, Inc. All Rights Reserved.
Figure 3-14 Printer Status Dialog
PSA-66-ST
Firmware Download Utility Instructions
PUBN Page 17 of 22 11/30/2004
PUBN-000015 REV.A