FutureLogic PSA-66-ST Instructions Manual page 11

11. Power down the printer.
12. Double-check the results by printing a self test ticket.
a. Pull the printer out of the Stationary Module until the FEED button is visible.
b. Press and hold the FEED button while powering up the printer.
c. Continue to hold the FEED button until the ticket starts to print, then release.
This self test ticket will show the firmware version that is loaded. Double-check this against
the version printed on the prior test ticket (step 9). Also, check the library inventory. There
should be entries for Templates, Print Regions, and System Resources.
Copyright © 2004 FutureLogic, Inc. All Rights Reserved.
Figure 2-11 Printer Status Dialog
PSA-66-ST
Firmware Download Utility Instructions
PUBN Page 8 of 22 11/30/2004
PUBN-000015 REV.A