Using The Download Utility - FutureLogic PSA-66-ST Instructions Manual

Figure 3-6
3. Slide the printer into a Stationary Module on the PSA-66 4-Station Stand.
4. Repeat steps 1 through 3 for each printer.
5. Connect the PSA-66 4-Station Stand to the PC using a D-9 male adapter cable.
6. Connect the power cable of the PSA-66 4-Station Stand.
Connect to
Power Cable
3.3

Using the Download Utility

Verify that you have installed the FutureLogic, Inc. Download Utility. You can acquire this
software from the FutureLogic, Inc. Web site (http://www.futurelogic-inc.com) or CD-ROM.
Note: The main window of the Download Utility displays a tab marked Auto Download.
Additional tabs for each communications port you select on the Auto Download
Preferences dialog display as well.
When the Download Utility detects a printer connected to a communications port, the
tab for that port displays "Printer Found." If not printer is detected, the tab for that port
displays "??No Printer??".
To change the firmware using the PSA-66 4-Station Stand:
1. Access the Download Utility.
Copyright © 2004 FutureLogic, Inc. All Rights Reserved.
Connect the Ribbon Cable to a Daughter Board
Figure 3-7 PSA-66 4-Station Stand – Rear View
PSA-66-ST
Firmware Download Utility Instructions
Connect to
Adapter Cable
PUBN Page 13 of 22 11/30/2004
PUBN-000015 REV.A