3. If you can access the Ribbon Cable which attaches the Sliding Module to the Stationary
Module, go to the next step.
If you cannot access the Ribbon Cable because of the Paper Tray, grab the back of the
Paper Tray by the back fin and rock it forward, pulling it out of the unit.
4. Release the Ribbon Cable by spreading the finger latches at the rear of the unit.
Note: The black end of the Ribbon Cable connects to the rear Daughter Board. The gray
end of cable connects to main controller.
5. Press in the Release Lever under the front of the Sliding Module to release the locking
mechanism.
Copyright © 2004 FutureLogic, Inc. All Rights Reserved.
Figure 3-1
Slide the Unit until It Locks
Figure 3-2
Pull Out Paper Tray
Figure 3-3
Eject the Ribbon Cable
PSA-66-ST
Firmware Download Utility Instructions
PUBN Page 11 of 22 11/30/2004
PUBN-000015 REV.A