Page 1
Warranty: Information in this manual is given in good faith for the benefit of the user. It cannot be used as the basis for claims against Kingfisher International or its representatives, if accidental damage or inconvenience results from use or attempted repair of the equipment.
2. The Instrument Figure 1: Front view Optical ports Rubber holster Revision 7 Date: 22 Jun 2020 Page 4 of 13...
Page 5
Figure 2: Top View OLT Port ONT Port ONT Port: for 1310nm upstream signal test. OLT Port: 1490/1550 nm downstream signal test. Figure 3: Side View USB connector: Connects instrument to a computer. Charging Hole: Insert connector of the charger to charge instrument (for KI6102-XX series only).
3. Operation Instructions 3.1 ON/OFF Instrument Press and hold [ON] to turn on instrument; the Home Display below will be seen on screen as shown below. The instrument is now ready for measurements. Powers levels of the respective wavelengths will be displayed automatically when live fibers are appropriately connected to the OLN &...
3.3 Back Light Backlight turns on when instrument is first turned on and goes off after 30 sec. When backlight is off, press any key to turn it back on for 30 sec. 3.4 Selecting Measurement Unit At Home Display, press [F2] to select measurement unit (dBm or W). 3.5 Relative Measurement Mode At Home Display, press and hold [▼] to enter Relative Measurement mode;...
Page 8
Use [▲, ▼] to change value of selected digit and [▼] to change the sign (positive or negative) of a set value. Set the 3 displayed thresholds types (see below) with the desired values: ALARM (displayed as “ ! ”) PASS (displayed as “...
Choose a threshold group number (from the available 01, 02, 03) using [▲, ▼]. Press [OK] to activate Pass/Fail display mode. Press and hold [OK] to de-activate Pass/Fail display mode. 3.8 Setting Time At Home Display, press and hold [►] to enter Time Setting mode. Use [◄, ►] to select digit to be edited;...
To read retrieve/read saved data: At Home Display, press and hold [◄] to enter Data Browsing mode, see picture below. Selected test data record number Indicates Data Browsing mode Use [▲, ▼] to choose test data record saved in instrument’s memory. The chosen test data record is displayed with date, record number and time information.
4. Maintenance 4.1 Keep the sensors’ surfaces clean and free of dust or other contaminant by cleaning them regularly. 4. 2 Do not use unclean or nonstandard adapters. 4.3 Change adapter carefully if necessary and keep any spare adapter in dirt/dust free environment.
5. Content of Packing Description Quantity KI6102-APC KI6102AA-APC AA Battery External power supply/charger PON Power meter User manual Soft carry pouch SC/APC--SC/APC or SC/PC--SC/PC Patchcord Software CD USB cable Cleaning cotton stick pack For KI6102-xx series, select from the option part number listed below to order suitable AC power adapter plug if needed;...
Page 13
Storage During prolonged storage, remove batteries to eliminate the possibility of acid leakage. Use only high quality batteries. Revision 7 Date: 22 Jun 2020 Page 13 of 13...
Need help?
Do you have a question about the KI6102 Series and is the answer not in the manual?
Questions and answers