Briggs & Stratton 1696715-00 Operator's Manual page 6

WARNING
This machine is capable of throwing objects that could
injure bystanders or cause damage to buildings.
3. Before you start the engine, move the snowthrower
outdoors and away from windows and doors.
WARNING
Engines give off carbon monoxide, an ordorless, colorless,
poison gas. Breathing carbon monoxide can cause nausea,
fainting, or death.
• Start and operate the engine outdoors.
• Do not operate the engine in an enclosed area, even
if doors or windows are open.
4. Make sure that the operating area is clear of bystanders,
especially children.
WARNING
This snowthrower is capable of amputating hands and feet,
and throwing objects. Read and obey the safety instructions
in this manual. Failure to do so could result in death or
serious injury.
• Keep children out of the area during operation.
• Children are often attracted to the equipment. Be
mindful of all persons present.
• Be alert and turn the unit off if bystanders enter the
area.
• Use extra care when you approach blind corners,
shrubs, trees, or other objects that can obscure vision.
Engine
Oil Recommendations
Oil Capacity: See the Specifications section.
NOTICE
This engine was shipped from Briggs & Stratton without oil.
Equipment manufacturers or dealers may have added oil
to the engine. Before you start the engine for the first time,
make sure to check the oil level and add oil as specified
by the instructions in this manual. If you start the engine
without oil, it will be damaged beyond repair and will not be
covered under warranty.
We recommend the use of Briggs & Stratton
Certified oils for best performance. Other high-quality
detergent oils are permitted if classified for service SF, SG,
SH, SJ or higher. Do not use special additives.
Outdoor temperatures determine the correct oil viscosity
for the engine. Use the chart to select the best viscosity
for the outdoor temperature range expected. Engines on
most outdoor power equipment operate well with 5W-30
Synthetic oil. For equipment operated in hot temperatures,
®
Vanguard 15W-50 Synthetic oil gives the best protection.
6
A
B
C
D
E
Check and Add Oil
NOTICE
The engine was shipped from the factory without oil. Before
you start the engine, make sure that you add oil according
to the instructions in this manual. If you start the engine
without oil, it will be damaged beyond repair and will not be
covered under the warranty.
Use Briggs & Stratton Synthetic 5W-30 Warranty Certified
oil for best performance. Other high-quality detergent oils
are acceptable if classified for service SG, SH, SJ or higher.
Do not use additives.
1. Put the unit on a level surface (Figure 3).
3
®
Warranty
2. Clean the oil fill area.
3. Remove the dipstick (A, Figure 4 ) and any remaining oil.
SAE 30 - Below 40 °F (4 °C) the use of SAE 30 will result in hard
starting.
10W-30 - Above 80 °F (27 °C) the use of 10W-30 may cause
increased oil consumption. Check the oil level frequently.
5W-30
Synthetic 5W-30
®
Vanguard Synthetic 15W-50