Pressure Limiters - Barbco TRIBOR Series Operation Manual

PRESSURE LIMITERS- The transmitter is ON and Active. Master Thrust and Rotation Brakes are off.
Thrust Limiter
Button
The Pressure Limiters are always on when the drill is active. Limiter set points are displayed with the blue
bars on the pressure scales as shown above. Maximum pressure are identified by red bars.
1- Adjusting the thrust and rotation set points-
a. Push the Rotation Limiter Button in and hold.
b. Use the Up and Down Arrow Buttons at the bottom of the display in the corresponding
direction until the desired pressure setting is obtained.
c. Pressure limiters are set.
d. To set the thrust limiter repeat steps a. thru c.
32
Adjustment Buttons
Operation
Rotation Limiter
Button
Max Set Points
Limiter Set Points