Table of Contents
Advertisement
TRACK ASSEMBLY
The use of this machine requires a concrete pad to be poured.
Make sure to add hold down provisions to the middle, and both ends of the track. Failure to do so will
result in damage to the ends of the track, cylinders, pinion gears and other driveline components!
To install the extension tracks, follow the steps below.
1.
Place the master track up against the backstop.
2.
Place the consecutive track sections up against the master track. One after the other, tight
against each other.
3.
Aligning the top of the joints and bolting them together loosely. Use all bolt holes.
Do not tighten the end
gusset bolts at this step
4.
Start all four bolts thru the doughnut line up brackets on each side of the track. Starting with the
piece of track up agenst the master first.
Tighten both bolts on the
right side then both bolts
on the left side. The
track rails will align when
5.
Tighten all end gusset bolts.
6.
Repeat steps 2 thru 5 for each consecutive track section.
Before setting the machine, make a final check of the line and grade the track. Making sure it's
7.
consistent with the drilling method and bore path.
8.
Secure the track in place as needed.
tightened.
Set Up
21
Advertisement
Table of Contents
