Table of Contents
Advertisement
Rack Gear Assembly
9.
Place the master rack gear on top of the master track and back against the stops.
EXTENTION SECTIONS
LINE UP HARDWARE
MASTER RACK GEAR
10.
Place extension sections down the length of the track assembly, up against each other.
11.
Place the lineup gear against the inside seam. Match up the gear teeth with the holes as shown
in the photo above and tighten bolts. Do this for every section.
12.
Measure the distance from the rack gear to the inside of the track rail. Make sure both ends of
the assembled rack gear are centered up with the track. Flip up the barrel bolt and tighten the
ends down.
13.
Measure the center of the rack gear. Pry over as needed to center and tighten the remaining
barrel bolts.
14.
Secure the track to the pit floor.
*The track is ready for the machine assembly.
HOLD DOWN
BARREL BOLTS
STOPS
Advertisement
Table of Contents
