Setting And Aligning The Track - Barbco TRIBOR Series Operation Manual

SETTING AND ALIGNING THE TRACK

The most critical part of the bore is the setting of the machine track on line and grade. If the alignment
is not right when you start, it is not likely to improve.
CAUTION! EQUIPMENT HAZARD!
lift will cause damage to the cylinders, pinion gears and other driveline components!
CAUTION! EQUIPMENT HAZARD! Always set single track sections. Never lift more than one
track section at a time. Damage to end gussets will occur.
NEVER WELD
ON TRACK RAIL!
THIS WILL DAMAGE
MACHINE ROLLERS
AND SENSORS
WILL ACCURE
WARNING! Always use correct lifting devices and NEVER hoist or transfer loads over personnel!
Lift and place the master track in the pit with the push plate against the backstop. Use a string and
plumb bob to align the master track with the line of the proposed bore. Note that the track sections are
not numbered. They are symmetrical and can be connected from either end.
20
You must hold the track down! Allowing the track to
Set Up