DataTrak Operation
Replace DataTrak Battery or Fuse
To reduce the risk of fire and explosion, the battery
and fuse must be replaced in a non-hazardous loca-
tion.
Use only an approved replacement battery, shown
in T
2, and an approved fuse, shown in T
ABLE
Use of an unapproved battery or fuse will void
Graco's warranty and Intertek and Ex approvals.
Replace Battery
1. Unscrew cable from the back of the reed switch
assembly. See F
. 6.
IG
2. Remove the cable from the two cable clips.
F
. 6. Disconnect DataTrak
IG
3. Remove DataTrak module from bracket. See F
Take module and attached cable to a non-hazard-
ous location.
F
. 7. Remove DataTrak
IG
22
ABLE
Cable
Reed
Switch
Assembly
ti11992a
IG
ti11884a
4. Remove two screws on back of module to access
battery.
5. Disconnect the used battery and replace with an
approved battery. See Table 2.
Table 2. Approved Batteries
Energizer® brand alkaline # 522
Varta® brand alkaline # 4922
3.
Ultralife® brand lithium # U9VL
Duracell® brand alkaline # MN1604
. 7.
3A7004B