Replace The Hose - Graco SoloTech i6 Repair And Parts Manual

Replace the the Hose Hose
Replace Replace the Hose
Remove Remove the Remove the the Hose Hose Hose
1. Follow the Pressure Relief Procedure, page
2. Follow the steps
under Drain the Lubricant, page
Remove the Front Cover, page
3. The roller must be moved to remove the hose.
Follow the directions for your pump to move the
roller between the 4- and 8-o'clock positions
while pulling on the hose at the bottom until the
hose is free from the roller.
AC Models: Models: Loosen the screws and remove
a. AC AC Models:
the motor fan cover (FC). Turn the fan by
hand to move the roller.
NOTE: NOTE: Low RPM pumps and high ratio NOTE:
gearboxes may require many turns of the
motor fan to move the roller.
b. BLDC BLDC BLDC Models: Models: Models:
i. Insert the shaft socket tool (59) into the
back of the gearbox.
ii. Use a socket wrench to move the roller.
iii. Remove the socket from the gearbox.
3A3367L
4. Use a wrench to remove the four nuts (35) from
10.
10, and
10.
5. Use a 7mm wrench or a flat-headed screwdriver
6. Pull the barb assembly off of the hose on one
7. Grasp the hose (14) from the inside of the pump
8. Remove the second barb assembly, the gasket
9. Pull the other end of the hose into the pump
10. Remove and safely discard the used hose per
NOTE: To continue with disassembly, see NOTE: NOTE:
Remove the Roller, page
hose, continue with the next section.
Figure 2 Remove or Install the Hose
the hose barb assembly on one port. Pull the
hose so it extends about 2–3 in. (51–76 mm)
out of the pump. Remove the nuts (35) from the
barb assembly on the other port, and pull the
hose so it extends about 2–3 in. (51–76 mm) out
of the pump.
Pump Model
i6, i10, h10, i16, h16,
i23, h25
i26, i30, h32
to loosen the hose clamps (24).
side, then remove, the gasket (25) and clamp
(24).
housing and pull it into the pump housing and
out of the front. Drain the hose contents into a
bucket.
(25) and the clamp (24).
housing and out of the front.
your facility's waste disposal policy. Wipe clean
the inside of the pump housing.
13. If you are replacing the
Repair
Wrench size
10 mm
13 mm
11