Purge Air And Flush The Fluid Lines - Graco Reactor E-10 Instructions-Parts List Manual

Installation
To prevent cross-contamination of fluids and
equipment parts, never interchange component A
(isocyanate) and component B (resin) parts or
containers.
Have at least two 5 gal. (19 liter) pails to transfer fluid
from drums to supply tanks. Label one pail "A" and
the other "B", using the red and blue labels provided.
Always doublecheck which material you have before
pouring it in the supply tanks. Pouring is easier if pails
are not filled to the top.
Open only one supply tank at a time, to avoid
splashing material from one tank into the other when
filling.
20
NOTICE
Purge Air and Flush the Fluid
Lines
1. Remove both recirculation tubes (P) from the tanks
and secure each one in a dedicated waste
container.
2. Set function knob to Park
3. Plug in the power cord(s). See T
4. Open both pump fluid inlet valves (V).
5. Turn on Motor Power.
6. Set Spray valves to Recirc.
P
TI7022a
.
2, page 17.
ABLE
V
311075ZAB