Maintenance - Graco Reactor E-10 Instructions-Parts List Manual

Maintenance

• Check the pump wet-cups fluid level daily, Fill the
Wet-Cups, page 19.
• Do not overtighten the packing nut/wet-cup. The
throat u-cup is not adjustable.
• Keep component A from exposure to moisture in
atmosphere to prevent crystallization.
• Wipe the supply tank lid o-ring and inner rim daily to
prevent ISO crystallization. Keep a film of grease on
o-ring and inside of lid.
• Check the desiccant filter weekly. The filter is blue
when fresh, and turns pink when saturated.
• Remove plug (X) and clean fluid inlet strainer (51a)
as needed. Always clean the fluid inlet strainers
after flushing.
51a
X
311075ZAB
• Generally, flush if you will shutdown for more than
three days. Flush more often if material is moisture
sensitive and humidity is high in the storage area, or
if material may separate or settle out over time.
• If using an impingement mix gun, close gun fluid
valves A and B when not spraying. Doing this will
keep the internal parts of the gun cleaner and
prevent crossover. Clean the gun mix chamber
ports and check valve screens regularly. See your
gun manual.
• If using an Fusion Air Purge impingement mix
gun, always grease the gun after use until purge air
carries grease mist out the front of the gun
your gun manual.
Maintenance
.
See
27