Sungrow Logger3000 User Manual page 61

User Manual
step 3 Optional) When "PLC access" is set to "Enable", click "Set PLC Net ID". In the pop-up
window, follow the interface prompts to set the master node, set the slave node, restart
the master node, and restart the slave node. Then, click "Save and Exit".
- - - - E E n n d d
9.10.13.2 Ethernet
Perform Ethernet settings on this interface.
step 1 Click "System" -> "Interface" -> "Ethernet" to enter the corresponding interface.
step 2 If auto IP allocation is
ETH port by connecting the WiFi module and logging into 11.11.11.1.
P P o o r r t t
ETH1
ETH2
step 3 If the parameter "Automatically obtain IP settings (DHCP)" is set to
information such as the IP address, subnet mask, and default gateway, and click the
button
- - - - E E n n d d
9.10.13.3 AI
step 1 Click "System" -> "Interface" -> "AI" to enter the corresponding interface.
step 2 Select an input type, set the lower limit and upper limit, and click the button to save the
operation.
A A I I P P o o r r t t
AI1
AI2
AI3
AI4
- - - - E E n n d d
9.10.13.4 DI
step 1 Click "System" -> "Interface" -> "DI" to enter the corresponding interface.
step 2 Set the initial status to "NO" or "NC", and click the button to save the operation.
, it is recommended to obtain the current IP address of the
D D e e f f a a u u l l t t I I P P
12.12.12.12
13.13.13.13
to save the operation.
I I n n p p u u t t T T y y p p e e
Voltage (V)
Current (mA)
Voltage (V)
Current (mA)
Voltage (mV)
Voltage (mV)
V V i i r r t t u u a a l l I I P P
14.14.14.14
15.15.15.15
L L o o w w e e r r S S a a m m p p l l i i n n g g
L L i i m m i i t t
0
4
0
4
0
0
9 Web Interface
, fill in the
U U p p p p e e r r S S a a m m p p l l i i n n g g
L L i i m m i i t t
10
20
10
20
100
100
55