Connection To The Mains; Master/Slave Operation; Operation; Menu Structure - EuroLite TMH XB-280 User Manual

Connection to the mains

The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1 Connect the device via the enclosed mains cable to a grounded mains socket. Thus the unit is connected
to the mains.
2 Disconnect the power plug in order to disconnect the device from the mains.
3 Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave-devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT-jack with the DMX IN-plug of the next device.
Define the master device by setting the desired master mode "Sound, Random, Auto 1 or Auto 2" under Run
mode in the main menu. Set the slave devices to "DMX". Please refer to the instructions under Menu
structure.

OPERATION

With the power switch, you can switch the device on and off.
After you connected the effect to the mains, the device starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.
The display shuts off after 10 seconds of inactivity. By pressing any button it lights up again.
In the event of an operating fault, the Err control indicator next to the display lights up. Service operations
are only to be carried out by authorized dealers.

Menu structure

The Control Board offers several features: you can easily set the starting address, run the pre-programmed
programs or make a reset.
Press the OK button until the display is lit.
You can now use the OK button to select Set, Manu or Sys.
Press the OK button to enter the respective menu item of the main menu and confirm again with the OK
button.
You can move through the main menu by pressing the UP or DOWN buttons. Press the OK button to select
the desired menu item.
You can change the selection by pressing the UP or DOWN button. Confirm each change by pressing the
OK button.
You can leave the respective mode by pressing the (MENU or ENTER) buttons.
31/40 00127924, Version 1.0