EuroLite TMH XB-280 User Manual page 33

PAN-TILT Encoder / automatic PAN/TILT correction (Feedback)
With this function, you can correct the PAN/TILT movement to the programmed position.
DMX signal / action if no DMX
With the function, you can "keep" or "clear" the DMX value if there is no DMX-signal.
Lamp on by power on
With this function you can select if the lamp will be switched on when switching the power on. Select "ON"
by pressing Up or Down if you wish to enable this function or "OFF" if you don't.
Linear color / switch color change from step to linear color
With this function, you can select the linear change of the color wheel.
Load default
With this function, you can restore the factory settings of the device. All settings will be set back to the
default values (shaded).
Manu
Test function of each channel
With this function you can test each channel on its (correct) function.
Sys
DIS
With this function, you can display the software version of the display.
MT
With this function, you can display the software version of the PCB.
Reset Cal
With this function, you can calibrate the channels to their correct positions.
System errors
With this function, you can display error messages.
DMX monitor
With this function, you can display the current DMX addresses of the channels.
Lamp Hours
With this function, you can display the operating hours of the illuminant.
Total lamp Hours
With this function, you can display the total operating hours of the device.
.
33/40 00127924, Version 1.0