Before first Use
Remove the angle grinder and the accessories for the packaging. Keep
packaging material out of reach of children. There is risk of suffocation!
Intended Use
This angle grinder is intended for cutting and grinding metal and stone with the
suitable discs.
Setup
Please make sure the power mains voltage corresponds to the operating
voltage stated on the type label.
Attaching the Auxiliary Handle
Do not operate the angle grinder without the auxiliary handle (1). There are
two threaded mounting holes (4) in the transmission housing, one in each side,
to which the auxiliary handle (1) can be attached.
Inserting/Changing the Disc
Please Note! Always pull the power plug before changing a disc to avoid
accidental starting.
1. Lossen the spindle (7) with
the included face wrench
(6). Keep the shaft lock (2)
pressed to lock the drive
shaft and the disc.
2. Insert the cutting disc resp.
replace
the
Make sure to attach the
inner flange first (8), than
the cutting disc and finally
the outer flange (9).
Operation
worn
disc.
Cutting Disc
16
Shaft Lock
Safety Hood
Inner Flange
Outer Flange