Before First Use; Installing/Replacing The Sanding Belt - Westfalia 91 91 04 Original Instructions Manual

Before first Use

Remove the unit and the accessories for the packaging. Keep
packaging material out of reach of children. There is risk of
suffocation!
The Attachment is intended only for Use with the
Attaching and Detaching the Attachment Base and Sanding
Arm
When undertaking maintenance or mechanical work, always
disconnect the angle grinder from the power mains.
1. Screw the driving roll (8) onto the shaft of the angle grinder. The
attachment base is attached to the mounting collar for the
protective hood. Place the attachment base over the mounting
collar. Make sure that the collar is inserted all the way. Align the
attachment base and tighten the clamping screw (2).
2. To remove the attachment base, first remove the sanding belt.
Loosen the clamping screw and remove the attachment from the
angle grinder.

Installing/Replacing the Sanding Belt

When undertaking maintenance or mechanical work, always
disconnect the angle grinder from the power mains.
1. Remove the cover (7) from the attachment base. To do so
remove the internal hex screw which secures the cover.
2. Slacken the sanding belt (1) by tilting the lever (4) to either side
and thereby pulling the sanding arm back into the machine.
3. Remove the sanding belt (1) from the machine and insert the
new sanding belt. Please observe the direction arrow on the
Operation
Attention!
Angle Grinder 91 89 56!
11