Banner E-Stop ES-TN-14H5 Instruction Manual page 16

E-Stop Safety Modules with Adjustable Delay –
Figure 8. E-Stop Safety Modules ES-TN-14H5 and ES-TN-14H6 enclosure dimensions
NOTE: Do not attempt any repairs to the ES-TN-14H5 or -14H6 Emergency Stop
Safety Module. They contain no field-replaceable components. Return the
Safety Module to the factory for warranty repair or replacement.
If it ever becomes necessary to return an E-Stop Safety Module to the factory, please
do the following:
1) Contact the Banner Factory Application Engineering Group at the address or at
the numbers listed below. They will attempt to troubleshoot the system from
your description of the problem. If they conclude that a component is defective,
they will issue an RMA (Return Merchandise Authorization) number for your
paperwork, and give you the proper shipping address.
2) Pack the E-Stop Safety Module carefully. Damage which occurs in return shipping
is not covered by warranty.
P/N 68436 rev. A
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Repairs
WARRANTY: Banner Engineering Corp. warrants its products to be free from defects for
®
one year. Banner Engineering Corp. will repair or replace, free of charge, any product of its
manufacture found to be defective at the time it is returned to the factory during the warranty
period. This warranty does not cover damage or liability for the improper application of
Banner products. This warranty is in lieu of any other warranty either expressed or implied.
Models ES-TN-14H5/-14H6
WARNING . . .
!
Abuse of Module After
Failure
If an internal fault has
occurred and the Module will not reset,
do not tap, strike, or otherwise attempt
to correct the fault by a physical impact
to the housing. An internal relay may
have failed in such a manner that its
replacement is required.
If the Module is not immediately
replaced or repaired, multiple
simultaneous failures may accumulate
such that the safety function can not be
guaranteed.