Pureeing - Silvercrest SHMSB 300 A2 Operating Instructions Manual

2) Push the whisks 8 or the kneading hooks 9
into the slots 7 until they click audibly into
GB
place and are secure.
3) Insert the mains plug 4 into a mains power
socket.
4) To start operating the appliance, move the speed
switch 2 to the desired speed setting. You
can select between 5 speed settings and also
use the Turbo button 3 (see section "Speed
levels").
5) Press the tool release button 1 to release the
whisks 8 or the kneading hooks 9.
NOTE
For safety reasons, the whisks 8 and kneading
►
hooks 9 can only be released if the speed
switch 2 is set to position "0".

Pureeing

WARNING! RISK OF INJURY!
► Never use containers made from glass or
other easily breakable materials. These con-
tainers may be damaged and cause injuries.
6
Always insert the kneading
hook 9 or the whisk 8
without the ring into the
intended slot on the appli-
ance (labelled with an icon).
Always insert the kneading
hook 9 or the whisk 8 with
the ring on the shaft into the
intended slot on the appli-
ance (labelled with an icon).
ATTENTION! DAMAGE TO PROPERTY!
Never use the blender 0 for hard foodstuff s
►
such as: coff ee beans, ice cubes, sugar,
cereals, chocolate, raw/hard vegetables etc.
This could result in serious damage to the
appliance.
1) Open the fi xture with the safety cover 5 and
hold the safety cover fi rmly.
NOTE
The blender 0 can only be used if the
►
whisks 8 or the kneading hooks 9 are not
installed.
2) Push the blender 0 into the fi xture 5, push
it down and tighten it by turning fi rmly several
times in the direction of the arrow .
3) To avoid overfl owing, the container used for
blending should only be fi lled to about 2/3 of
its capacity. Select a suitably large container
or use the supplied measuring jug q.
NOTE
► In order to ensure that the ingredients are
properly mixed, the food that is being pro-
cessed should cover at least the lower part
of the blender 0.
► Do not switch the hand mixer on until the
blender 0 has been inserted into the ingre-
dients to be blended.
4) Move the speed switch 2 to the "Blender"
setting (see chapter "Speed levels") and
press the Turbo button 3. Keep the Turbo
button 3 pressed down during the whole
procedure. The appliance stops as soon as it
is released.
ATTENTION! DAMAGE TO PROPERTY!
Do not operate the blender 0 continuously
►
for longer than 1 minute. After one minute of
use, allow the appliance to cool down fully.
SHMSB 300 A2