SoftBank Whiz Quick Manual page 2

3.Teaching a Cleaning Route
1
Pull the the Steering Handle
straight up until you reach the
joint and tilt the handle to lock
it into position
4
Tap "TEACH ROUTE"
7
Press the Vacuum Power Button
・Use the cleaning modes (Normal mode / Max power
mode) according to the condition of the floor.
・The switch between two cleaning modes will be
duplicated during autonomous cleaning.
10
Tap "Save Route," scan the
HLC again
Saving the cleaning route will take half the
time of teaching the cleaning route.
2
Move the Machine to the
Home Location Code
5
Scan the Home Location Code
If an error is displayed in a red frame,
adjust the distance of the Machine and
the code and scan it again.
8
Clean the entire teaching route
Even if you pause during
teaching, it will not affect the
cleaning when carried out
autonomously.
Please clean at your own pace.
Backward movements
will not be recognised
as a cleaning route.
Recharge the battery
Pull out the battery from the Machine, and recharge it in the charger.
About 4 hours are required for the battery to fullly recharge.
The battery operates for about 3 hours when cleaning in normal mode.
1.Open the battery door
Pull the bottom left of the
battery door toward you.
4. Remove the battery
from the Machine
Hold the handles with both
hands when pulling the battery
out.
3
3
Press the Main power switch
to turn it on ( l )
80cm (2.6ft)
60cm (2.0ft)
6
Select "+" to create a new
route
For each Home Location Code, six
cleaning routes can be saved.
9
Once cleaning is complete,
press the Vacuum Power
Button and turn the cleaning
mode off
2. Press the battery lock
Press the battery lock with Pull the batttery out toward you as
your right thumb. you release your thumb from the lock.
Be careful not to let your thumb get
caught.
5. Insert the battery into
the charger
The charging status Once the battery is properly inserted,
light flashes in orange. the lock in the battery compartment
will pop into place, making a "click".
The Charging
Status Light
*Once the battery is recharged,
the charging status light flashes in green.
3. Pull the battery halfway out
toward you
6.Insert the battery in the battery
compartment
2