Armature; Disassembling - Makita DTD152 Technical Information

3.3.2. ARMATURE

3.3.2.1. DISASSEMBLING

(29-33)
(31)
Tail of Torsion
spring
(32)
(30)
(8-28)
Figure 15
(32)
Notch of Brush
holder (32)
Figure 16
(31)
Tail of Torsion
spring
Figure 17
(29)
Figure 18
1. Remove Hammer case section (8-28) from Motor section
Figure 15)
(29-33). (See
2. Shift the tail of Torsion spring from the top of Carbon
brush (31) to the Notch of Brush holder complete (32).
Carbon brush (31) gets free from the pressure of Torsion
spring.
Note: When shifting Torsion spring's tail, hold Torsion
spring not to fall off from Brush holder complete
(32).
3. Disconnect Carbon brush (31) from the commutator of
Armature (30) by pulling it up.
4. Disassemble Armature (30) and Yoke unit (29) from Brush
holder complete (32).
July 2015
11 / 27