Anvil; Disassembling - Makita DTD152 Technical Information

(31)
Tail of Torsion
spring
(5)

3.3.3. ANVIL

3.3.3.1. DISASSEMBLING

(28) (27)
(26)
(32)
Notch of Brush
holder (32)
Figure 26
Concave
portion
Projection
(6)
Figure 27
(17-25) (8-16)
Figure 28
8. Insert Carbon brush (31) into Brush holder complete (32).
Shift the tail of Torsion spring from the Notch of Brush
holder complete (32) to the top of Carbon brush (31).
Carbon brush (31) is locked with the pressure of Torsion
spring.
Note: When shifting Torsion spring's tail, hold Torsion
spring not to fall off from Brush holder complete
(32).
9. Fit the concave portion of F/R change lever (5) to the
projection of Switch unit (6).
1. Remove Hammer case section (8-28) from Motor section
Figure 6)
(29-33). (See
2. Remove Bearing box complete (28), O ring 40 (27),
Internal gear 51 (26), Hammer section (17-25) from
Hammer case complete section (8-16). (See
Figure 9)
Note: When repairing Bit holder section only, you need not
to disassemble Hammer case section (8-28).
July 2015
Figure 7
to
15 / 27