Assembling - Makita DTD152 Technical Information

(8)
1R212-A
(B)
(A)
(8)
(9) (10)
(8)

3.3.3.2. ASSEMBLING

Assemble by reversing the disassembly procedure. (See
Figure 6)
(13)
1R232
Figure 29
1R212-B
(11) 1R003
Figure 30
(15)
(11) (15) (16)
Figure 31
3. Use 1R232 for holding Anvil (16) inside of Hammer case
complete (13) firmly for easy removal of Ring spring 11
(8).
4. Remove Ring spring 11 (8) while checking the following
points.
(A) Press the top of Bit sleeve (11) with a thumb so as not to
pop out Compression spring 13 (10).
(B) Expand the end gap of Ring spring 11 (8) with 1R003,
1R212-B and 1R212-A.
5. Bit holder section can be disassembled as shown in the
figure on the left:
- Ring spring 11 (8)
- Flat washer 12 (9)
- Compression spring 13 (10)
- Bit sleeve (11)
- Steel ball 3.5 (15) x 2
- Anvil (16)
Figure 31, Figure 30, Figure 29, Figure 28, Figure 9, Figure
July 2015
8, Figure 7,
16 / 27