Advertisement
Mounting the slide rails on the rack
The following procedure explains how to attach the telescopic slide rails to the rack.
1. Determine where on the rack you want to mount the NAS 100.
2. Depending on your rack type, use a screwdriver to insert the cage nuts or slide
the clip nuts into the appropriate holes. You will install two nuts on each side of
the back of the rack and three nuts on each side of the front of the rack (the top
nut is used for the mounting ear on the front of the NAS 100).
Note: Make sure that you insert each of the bottom nuts at the same height on
the rack so that the installed NAS 100 will be level.
5
4
1
1
Cage or clip (shown) nut
2
Front bracket
3
Back bracket
4
Left/right front mounting template
5
Left/right back mounting template
2
™
IBM TotalStorage
NAS 100 Rack Installation Instructions
3
5
Advertisement
