Advertisement
3. Attach the first bracket to the front end (the white end) of the telescopic slide
rail:
a. Locate the alignment screw hole on the front end of the outer telescopic
slide rail and align the bracket with it. The alignment screw hole establishes
where each screw will go in relation to the bracket. For most installations,
the alignment screw hole and bracket alignment will be the one illustrated in
the following figure.
A
1
Alignment screw hole
2
Bracket
3
Outer telescopic slide rail
Note: You will have to slide the inner ball-bearing slide rail and the inner
telescopic slide rail back and forth to align the oval cutout with the
screw hole so that you can insert the screw.
b. Insert an M4 screw through the bracket and in the alignment screw hole,
fasten a washer and an M4 nut to it, and firmly tighten them. Repeat this
step with three more screws in the remaining holes.
4. Extend the slide rails fully.
A
1
2
™
IBM TotalStorage
NAS 100 Rack Installation Instructions
3
3
Advertisement
