Advertisement
Installing the NAS 100 in the rack
The following procedure explains how to install the NAS 100 in the rack.
1. Fully extend the telescopic slide rails out of the rack until they lock.
2. Insert the NAS 100 backwards into the rack so that the server slide rails slide
3. Pull the white spring tabs on the server slide rails to insert the NAS 100 fully
4. Push the server firmly into the rack to secure it.
5. Use the mounting ear thumbscrews to attach the NAS 100 to the rack.
6. Refer to the IBM TotalStorage NAS 100 Hardware Installation and Service
8
NAS 100 Rack Installation Instructions
into the main part of the telescopic slide rails.
1
Spring tab
into the rack.
Guide, GA27-4311 to complete the installation of the NAS 100.
Note: After you have attached all the cables to the NAS 100, use the cable
spiral wrap and cable ties to aid in cable management.
1
Advertisement
