Advertisement
5. Loosely attach the next bracket to the back end of the telescopic slide rail with
6. Hold the slide rails with the attached brackets up to the rack and check that the
7. Repeat this process with the other telescopic slide rail and brackets.
4
NAS 100 Rack Installation Instructions
four more M4 screws, washers, and nuts, as shown in the following figure.
1
Telescopic slide rail
2
Bracket
Note: Do not completely tighten these screws until you install the slide rail into
the rack. This will make attaching the slide rail to the rack much easier.
After the slide rail is attached to the rack, you can tighten the screws on
the back bracket.
slide rails and brackets will fit in the rack. Make any necessary adjustments to
the back end of the slide rail and its bracket.
Note: Make sure that you install the screws in the other telescopic slide rail in
exactly the same places that you installed them in the first telescopic
slide rail.
1
2
Advertisement
