Westell Technologies Westell UltraLine 7400 User Manual page 97

User Guide
Interface
Metric
RIP
Host Routing Table
Destination Address
Netmask
Gateway
Interface
Metric
RIP
Inactive Routes
Destination Address
Netmask
Gateway
Interface
Metric
RIP
Add Route
Destination Address
Netmask/ Host Route
Gateway/IP Address
Metric
RIP Conf
Save to Modem
030-300381 Rev. A
Indicates were to send the packet if it matches this route.
The RIP metric to be assigned to this route if and when it is advertised using RIP.
Indicates whether a static route should be advertised via RIP.
Host Routing Table
The list of host routes. A host route is an IP route with a 32-bit mask, indicating a
single destination (as opposed to a subnet, which could match several destinations.)
The IP address or subnet of the Route.
If the Route is a network route, netmask is used to specify the subnet mask.
If the Route is a Host route, then the Host Route check box is used.
Indicates were to send the packet if it matches this route.
Indicates were to send the packet if it matches this route.
The RIP metric to be assigned to this route if and when it is advertised using RIP.
Indicates whether a static route should be advertised via RIP.
Inactive Routes
Static routes whose interface is currently not in service.
The IP address or subnet of the Route.
If the Route is a network route, netmask is used to specify the subnet mask.
If the Route is a Host route, then the Host Route check box is used.
Indicates were to send the packet if it matches this route.
Indicates were to send the packet if it matches this route.
The RIP metric to be assigned to this route if and when it is advertised using RIP.
Indicates whether a static route should be advertised via RIP.
Add Route
This is used to add a new static route in the Router.
The IP address or subnet of the Route.
If the Route is a network route, netmask is used to specify the subnet mask.
If the Route is a Host route, then the Host Route check box is used.
The interface to use for sending the packet, if it matches this route. (Only active
gateways can be used to create a static route.)
The RIP metric to be assigned to this route if and when it is advertised using RIP.
Determines whether or not to advertise the static route, using RIP. (RIP must also be
enabled before the route will be advertised.)
If checked, then the route will be made permanent by saving it to flash memory. If
not checked, the route will disappear the next time the Router restarts.
UltraLine Home DSL Router (Models 7400, 7401)
97 January 2004