Table of Contents
Advertisement
User Guide
NOTE: The Router features shown in Figure 1 apply to the Model 7400 product. The Model 7401 product has only
an Ethernet interface.
6.4.2 Installation via USB (Model 7400)
NOTE: The USB installation will not function for Macintosh computers. Macintosh computers must install
!
via Ethernet connection. See section 6.4.1.
1. Connect the power supply cord to the power connector marked
other end of the power supply into a wall socket.
2. Connect the DSL phone cable from the connector marked
equipped telephone line jack on the wall. You must use the phone cord that was provided with the kit.
3. Connect the blue USB cable from the blue USB connector marked
USB port on the PC.
4. Check to see if the DSL/RDY LED is solid green. If this LED is solid green, the Router is functioning properly.
Congratulations! You have completed the USB hardware installation for Model 7400. You must now go to section 7
to begin the USB driver software installation.
030-300381 Rev. A
Figure 1. Connection via 10/100 Base-T Ethernet
14
UltraLine Home DSL Router (Models 7400, 7401)
~
on the rear panel of the Router. Plug the
12V
on the rear panel of the Router to the DSL-
on the rear panel of the Router to the
January 2004
Advertisement
Table of Contents
