Table of Contents
Advertisement
User Guide
UltraLine Home DSL Router (Models 7400, 7401)
If you clicked on User Configured PC and then clicked enable, the following pop-up screen will appear. Click on
OK to enable this device for Single Static IP. Click on Cancel if you do not want to enable this device for Single
Static IP.
If you clicked on OK in the preceding pop-up screen, the following pop-up screen will appear. The Router must be
reset in order for the new configuration to take effect. Click on OK.
If you clicked on OK in the preceding screen, the following screen will be displayed. The Router will be reset and
the new configuration will take effect. After the Router has been reset, confirm that you have a DSL sync and that
your PPP session displays UP.
After a brief delay, the home page will be displayed. Confirm that you have a DSL sync and that your PPP session
displays UP. (Click on the connect button to establish a PPP session). Next, Select Single Static IP from the
Configuration menu to confirm that Single Static IP is enabled, as shown in the following screen.
030-300381 Rev. A
52
January 2004
Advertisement
Table of Contents
