Flow Direction Indicators Entry From Table; Load Data From External Eeprom; Store Data In External Eeprom; Software Version - ABB COPA-XE Instruction Bulletin

Electromagnetic Flowmeter
COPA-XE / MAG-XE
4.21.3 Flow Direction Indicators
Entry from table
The arrow on the flowmeter primary defines the direction of the
fluid flow for the forward direction. If this direction is indicated
in the process information display as reverse, select the
parameter "Inverse" in the direction indication menu to change
the display indicator to forward.
The ARROW keys can be used to select the appropriate
parameter in the "Direction Indication" submenu and accepted
by pressing ENTER.
Direc. Indication
normal

4.22 Load Data from External EEPROM

Load data from
ext. EEPROM
When a converter is exchanged the data are automatically
uploaded from the external EEPROM when the supply power is
turned on. It is also possible to upload the data at any time by
simply pressing a key.

4.23 Store Data in External EEPROM

After the initial start-up (at the site) the function "Store data in
ext. EEPROM" must be called once in order to copy all the
meter location specific data into the external EEPROM.
If a parameter is subsequently changed which should be saved,
this procedure should be repeated. Call the parameter and
initiate the procedure by pressing ENTER.

4.24 Software Version

The Model Number of the converter is displayed in the 1st line
while in the 2nd line the part number of the software is
displayed.
These parameters cannot be changed.
An example of a display is shown.
ED4
D699B180U01
3/99 =
B10 =
34
3/99
B10
Release date
Revision level
4.25 TAG-Number (Instrument Address for
Profibus-Communication)
Numeric entry
Tag Number
After pressing ENTER an alphanumeric Tag Number with up to
16 characters, upper and lower case letters and numbers, can
be entered to identify the meter location.
Scroll, using the DATA key, first through the lower case letters
followed by the numbers 0-9, the upper case letters and then
the symbols - / : . * _ . Use the STEP key to shift to the next
position and use the DATA key to enter the desired character.
Repeat this procedure until all the desired characters have
been entered and accept by pressing ENTER.
For Profibus-Communication the Instrument Address is to be
entered in this submenu. Factory setting: 127
4.26 Service Code Number
Numeric entry
Service-Code
The code number provides access to the adjustment routines.
Only for ABB Automation Products Service personnel.