Flowmeter Primary And Converter Coordination; Data Security - ABB COPA-XE Instruction Bulletin

1.

Flowmeter Primary and Converter Coordination

This Instruction Manual describes the assembly and installation, the electrical interconnections and the configuration of the
Flowmeter Systems COPA-XE and the Flowmeter Systems MAG-XE.
Compact Design COPA-XE
The µP-Converter and the flowmeter primary constitute a single
mechanical entity.
Aluminum Design: Models DE43F and DE43W
Stn. Stl. Design: Model DE23_
Flanged Wafer
Design
1.1

Data Security

All data is stored in a NV-RAM when the power is turned off or
during a power interruption. The parameter settings and
flowmeter primary specific calibration data are stored in a serial
EEPROM as well as in an external EEPROM. Therefore, after
a converter and EEPROM exchange all the stored data can be
readily uploaded into the new instrument.
COPA-XE
Multiple Process Connections
Stn. Stl.
Electromagnetic Flowmeter
Remote Design MAG-XE
The µP-Converter is mounted remote from the flowmeter
primary. Cable lengths up to 50 m may be used for conductivities
above 5 µS/cm. The electrical interconnection between the
converter and flowmeter primary are made in connection boxes
using a single signal cable.
Aluminum Design: Models DE41F and DE41W
Stn. Stl. Design: Model DE21_
19"
Rail Mount
Panel Mount
Flanged
Wafer
Design
!
Important Start Up Note
When the instrument is shipped the external EEPROM is
plugged into its socket on the display board of the converter.
Please check for correct coordination between the con-
verter and flowmeter primary. The last digits of the flowme-
ter primary serial number as indicated on the Instrument
Tag end in A1, A2 etc. while the corresponding end charac-
ters for the converter end in B1, B2, etc. A1 and B1 consti-
tute a single entity.
COPA-XE / MAG-XE
MAG-XE
Field Mount Hsg.
Multiple Process Connections
Stn. Stl.
1