EAGLEHAWK CONTROLLER – INSTALLATION & COMMISSIONING INSTRUCTIONS
M-Bus Connection Procedure
Install the PW M-Bus Adapter on DIN rail. Insert a
screwdriver into the slot in the DIN rail clamp on the
underside of the PW and pry downward to loosen clamp
until the unit snaps onto the rail.
Fig. 42. Mounting of PW (PW3 shown here)
Connect the M-Bus devices to the PW M-Bus Adapter.
All M+ and M- terminals are connected in parallel in the
PW M-Bus Adapter.
Fig. 43. PW M-Bus adapter connections
Connect the PW M-Bus Adapter to the RS232 / RJ45
socket of the EAGLEHAWK using the XW586 cable.
Fig. 44. Connecting the EAGLEHAWK to the PW M-Bus
Connect 24 V power to the M-Bus Adapter.
Risk of electric shock or equipment damage!
It is prohibited to power the EAGLEHAWK controller with
the same transformer used to power other controllers or
devices (e.g., the PW M-Bus Adapter).
Fig. 45. Connecting power to the PW M-Bus adapter
RS232 / RJ45