Honeywell CENTRA LINE EAGLEHAWK Installation & Commissioning Instructions page 6

EAGLEHAWK CONTROLLER – INSTALLATION & COMMISSIONING INSTRUCTIONS
USB 2.0 Host Interface
Fig. 5. USB 2.0 Host interface
USB 2.0 Device Interface
All models of the EAGLEHAWK controller are equipped with a
USB 2.0 Device Interface at the front. This interface is for
AX
connection to COACH and web browsers, or 3
panels.
Fig. 6. USB 2.0 Device Interface
A standard USB type-B connector can be inserted into this
USB 2.0 Device Interface. This USB 2.0 Device Interface is
the recommended interface for connection to COACH
Ethernet / RJ45 Socket
The EAGLEHAWK controller is equipped with an Ethernet /
RJ45 socket featuring one LED.
EN1Z-1005GE51 R0216
rd
-party touch
USB 2.0 Device Interface
AX
.
Ethernet / RJ45 socket
Fig. 7. Ethernet / RJ45 socket
This Ethernet / RJ45 socket is a 10/100-Mbaud Ethernet
interface permitting communication (as per IEEEC 802.3) on
any supported IP network, e.g.: BACnet (IP), FOX, etc.
Fig. 8. Ethernet / RJ45 socket
NOTE: The Ethernet / RJ45 socket is usually earth-
grounded. For additional information on earth
grounding, see also "Appendix 1: Earth Grounding"
on pg. 30.
LEDs
The EAGLEHAWK controller features the following LEDs:
Fig. 9. EAGLEHAWK controller LEDs
Table 4. EAGLEHAWK controller LEDs
color
symbol
Heartbeat LED indicating platform is
L1 yellow
running
L2 yellow LED indicating that station is starting up
RS485-1 status LED indicating trans-
Tx yellow
mission of communication signals.
RS485-1 status LED indicating reception
Rx yellow
of communication signals.
red status LED indicating hardware problems
!
green power LED
See also section "EAGLEHAWK Controller Troubleshooting"
on page 28 for a detailed description of the behaviors of the
LEDs and their meanings.
6
LINK/ACT.
function, description