Tilt Stand Installation With Add-On Modules - Toshiba Strara CTX Series Installation And Maintenance Manual

Tilt Stand Installation with Add-on Modules

This section explains how to attaching a tilt stand to a digital telephone with one or two ADMs. Follow
the instructions for the appropriate number of ADMs. Use Tilt Stand models "BTSA" (not "BTSD")
for DKTs with one or two ADMs.
To attach a digital telephone with one ADM to a Tilt Stand
1. Complete the steps under
2. Make sure bottom phone jack is plugged in.
3. Remove Tilt Stand from Tilt Stand Base (see
4. Place the spacers on the outer holes, as shown (see
5. Attach Tilt Stand to bottom of DKT with screws (see
6. Reinstall the Tilt Stand Base: Fit the Tilt Stand Base over the Tilt Stand so that the "bottom pegs"
fit into the holder. Adjust Tilt Stand so that the "top pegs" fit into the top Tilt Stand Base holes (see
Figure 7-22). Do this to both stands.
7. Pull up on the Tilt Stand Bases so that they open to the maximum angle (30 degrees).
8. Push in the Release button to adjust the tilt angle (0, 10, 20 or 30 degrees) of each Tilt Stand.
Spacer
Figure 7-21 Attach Tilt Stands to DKT and One ADM
Strata CTX I&M September 2002
"To install DADMs" on Page
1 ADM + 1 DKT
ADM
1 ADM DKT DKT
2 ADM
1 ADM
DKT 1 ADM
2 ADM 2 ADM
Put in three screws in the
positions marked "1ADM."
Insert a spacer beneath each stand as shown. Put in the
screw with the spacer first. Then insert the other two screws.
7-20.
Figure 7-22).
Figure 7-23).
Figure 7-21).
DKT
1 ADM 1 DKT DKT
2 ADM
1 ADM
1 ADM
2 ADM DKT 2 ADM
Put in three screws in the
positions marked "DKT."
Station Apparatus
Spacer
5599
7-23