Telephone Cord Connection; Connect And Apply Power To Base Unit - Toshiba Strara CTX Series Installation And Maintenance Manual

Station Apparatus
To mount on a wall
1. Select a wall location near a 120VAC outlet and within reach
of the Strata CTX digital line connection.
2. Place the wall plate (shown at right) against the wall, and with
a pencil, mark the position of the screws.With a punch tool,
punch "starter" holes in the wall.
3. Align the wall plate and screws on the wall where the "starter"
holes are and tighten down the screws.
4. Ensure that the wall-mount plate is placed on the wall so that
the "feet" are at the bottom when you are looking at the inside
of the plate.
5. Snap the Base Unit onto the plate.

Telephone Cord Connection

There are two telephone line jacks on the back of the base unit of
your cordless digital telephone: "Line In" and "Line Out." You can
connect the cordless digital telephone to both the telephone line
and a Strata CTX digital telephone.
To connect cords for use as a stand-alone telephone
Connect the modular jack labelled "Line In" to the telephone wall jack.
...or
To connect cords for use with a desk telephone
1. Unplug the telephone line cord from your desk telephone.
2. Connect this cord to "Line In" of your cordless telephone.
3. Using the two foot modular cord that came with your cordless telephone, connect the jack labelled
"Line Out" to the desk telephone.

Connect and Apply Power to Base Unit

The AC adapter furnished with this telephone may be equipped with a polarized line plug (a plug
having one blade wider than the other). This plug fits into the power outlet only one way. If you are
unable to insert the plug fully into the outlet, try reversing the plug. If the plug still does not fit, contact
your facilities coordinator about replacing the obsolete plug. Do not alter the shape of the blades on the
polarised plug.
7-32
4449
4507
Strata CTX I&M September 2002