Remote Cabinet Installation Instructions - Toshiba Strara CTX Series Installation And Maintenance Manual

Remote Cabinet Installation Instructions

All instructions apply to both the Base Cabinet and the Remote Expansion Cabinet except where
specifically noted.
1. Install cabinets according to the instructions given at the beginning of this chapter. Pay particular
attention to wiring and grounding instructions given for Remote Expansion Cabinets.
2. If installing a standalone Remote Expansion Cabinet, or the first in a stack, set the "BASE/EXP"
switch to "BASE" in accordance with
3. Cabinets in which RRCU cards are installed must be modified to protect the routing of the cables
through the cabinet.
Attach the plastic guide to the bracket provided with the RRCU1A card. See
Attach the bracket to the inner wall of the cabinet.
4. Install the RRCU Card
Select correct jumper options (see
the centre pin to the upper pin (M1, M2). On the Slave side, both option plugs connect the
centre pin to the lower pin (S1, S2).
Remove the protective rubber cap from the fibre connector on the ROMS1A daughterboard.
See Figure
5. Install a BCTC1A top cover on the topmost cabinet (see
Place lid over screws
and slide it to the right.
Figure 3-30 Remove/Replace Remote Cabinet Cover
Strata CTX I&M September 2002
3-33.
Figure 3-3.
Figure 3-32). On the Master side, both option plugs connect
Figure
Strata CTX670 Installation
Figure
3-30).
Top View
5030
3-31.
3-43