Ipt-To-Ip Network Connection Instructions - Toshiba STRATA CTX User Manual

IP Telephone Settings

IPT-to-IP Network Connection Instructions

IPT-to-IP Network Connection Instructions
1. Press + + +
2. Press , then press
3. Press
(normally, use : manual setting):
: manual setting, then press
: auto setting by DHCP server, then press
4. Press
an IP address, press the
"192.168.1.241," press
5. Press
mask address is "255.255.255.0, press
6. If the IPT is connected to a router or other gateway device, press
router address, then press
setting.
7. Press
telephone's primary number (PDN).
8. Press
the BIPU-M1A to which this IPT interfaces, then press
for CTX networked systems only.
9. Press
: manual setting, then press
then press
format
: auto setting by broadcast, then press
: auto setting by multicast (IPT doesn't support multicast setting in this first
release), then press
10. Press
11. Go off-hook and hang up. The IPT will search for the BIPU-M1A, initialize and
then set the IP address (from 20 sec. to 60 sec.). Time, Date and PDN displays on
LCD when the information is set.
See
Note
that you will see during this procedure.
110
(simultaneously).
to select the Network Setting Mode.
to see if the DHCP server is in use or not. Press one of the following
. Enter the IP address for this IPT and press
button on your dialpad (e.g., if the IP address is
. Enter the subnet mask number and press
. Enter a Station ID for the IPT and press
to enter the CTX Strata Net node number of the CTX node that contains
for BIPU IP address mode. Press one of the following:
. (e.g., if the BIPU IP address is "192.168.1.241," enter it in this
.
again to set all the above data.
"IP Telephone Start Up Sequence"
.
).
. Only used if Step 3, above, is set for manual
. Press
).
.
below for an explanation of the LCDs
.
. To enter the period in
. (e.g., if the subnet
).
. This is usually your
. This FB setting is
and enter the BIPU IP address,
Strata CTX DKT/IPT Telephone
. Enter the
10/04