Water Separator - BÖWE P25 Instruction Manual

11 Maintenance

11.5.3 Water Separator

To prevent odor buildup, drain the water trap daily into the process water tank or into the safety
separator.
Dispose of the process water according to the regulations in your country.
Work sequence:
- Open ball-cock (1) and lower the solvent level to below the lower edge of the drain pipe (2)
- Close ball-cock (1)
- Open ball-cock (2) and drain water phase
- Close ball-cock (2)
Drain the entire contents of the water separator once a week.
There are two steps. Step 1 is the draining of the water trap, as described above.
Step 2 is the draining of the entire residue into the still.
Work sequence for step 2:
- Open ball-cock (1) until the water separator is empty
- Close ball-cock (1)
- Clean water separator if necessary
- Remove safety linch pin (5)
- Open sight-glass clamp (3) and remove sight-glass with gasket
- Clean water separator and sight-glass
- Replace sight-glass with gasket and close the clamp
- Insert safety linch pin (5) and snap spring clip into place
47
11
703903-04-0
P25/P30