Summary Of The Maintenance Programs - BÖWE P25 Instruction Manual

11 Maintenance

11.3 Summary of the Maintenance Programs

P17 to P33 Free programming locations
P34 Deodorizing:
The following maintenance programs are installed in the P25/P30
P35 Prepare stock solution
P36 Distillation maintenance
P37 Transfer pumping of
distillation residues
P38 Pump out distillation
residues
P39 / Filter maintenance
P40
P41 Slimsorba maintenance
(only on machines with
Slimsorba)
P42 Rinse SPRAYMATIC
P43 Rinse back wall of cage
P44 Fill tanks
P45 Empty tank 1
P46 Empty tank 2
P47 Empty tank 3
41
Attention: Always select this if the loading door cannot
be opened.
Addition of drycleaning detergent in the work tank solvent
by preparation in the pump circuit, with dosing via the
dosing unit (manual operation); then drying with reduction
Still stripping and subsequent reduction or program
sequence "emission-free still rake out"
(only with emission-free still rake out system)
(only with emission-free still rake out system)
Start of automatic filter maintenance program with spinning
and simultaneous 50% draining to the still. Then additional
spinning and complete emptying into the still. Finally, filter
circuit and, if filter powder is used, precoating with the filter
powder. Pumping to work tank and spin to still with
subsequent drying and reduction.
If filter powder is used, fill the bag that comes with the
machine and put it in the cage before the start.
For desorption of the Slimsorba at times other than during
the cleaning cycles. The program has two phases:
desorption and carbon cool-down.
SPRAYMATIC is rinsed with solvent and then dried with
reduction.
Pump from work tank for rinsing and spinning the cage
with solvent. Then pump to distillation, followed by drying
with reductions.
Fill the clean tank, then overflow into the work tank
For pumping out the work tank. Empty the machine
For pumping out the clean tank. Empty the machine
For pumping out tank 3. Empty the machine
11
11.3
P25/P30