Refilling Solvent; Filling The Slimsorba Carbon Container (Optional Equipment) - BÖWE P25 Instruction Manual

6 Operation
To fill without emissions, proceed as follows:
- Remove the screw cap on the pump line.
- Connect a hose between the barrel and pump suction side.
- Connect gas displacement line between the barrel and water separator.
- Open the ball valve.
- Start program P44.
- The tanks fill up, with one overflowing into the other.
- Watch the level of the liquid in the tanks and stop program P44 when the tanks are full.
- Close the ball valve.
- Remove the connecting lines to the barrel.
- Screw the cap back on to the pump line.
- Remove the gas displacement line.
With c and o combinations:
- First fill the c machine with P44
- Next start P61 on the o machine in order to fill it.
- Then start P44 on the c machine again.
6.1.3

Refilling Solvent

Follow the procedure given in Point 6.1.2 for routine refilling of solvent.
Attention: Even empty containers can still hold solvent residues.

6.1.4 Filling the Slimsorba Carbon Container (Optional Equipment)

- Loosen the upper pipe flange on the carbon container.
- Loosen the quick release fastener on the cover and remove cover.
- Remove fine filter sieve and clamping ring.
- Fill in 12 kg (22 lb) of activated carbon (cylindrical pellets with approx. 4 mm (0.16 inch) diameter,
type Supersorbon K40). The heating coil must be covered.
- Replace the fine filter sieve and clamping ring.
- Replace the cover and close the quick release fastener.
- Secure the upper tube of the carbon container again.
Therefore tightly seal the container (barrel) again and
store or dispose of in accordance with regulations!
15
6
P25/P30