CITROEN BERLINGO MULTISPACE Handbook page 37

When the alarm has been triggered ten times
in succession (when triggered for the eleventh
time) it is deactivated. Repeat the procedure for
setting the alarm.
Locking the vehicle without
alarm
F Insert the key in the driver's door lock and
lock it.
Do not set the alarm when washing your
vehicle.
Failure of the remote control
When the alarm is set but the remote control
does not operate:
F Unlock the doors with the key and open the
door. The alarm is triggered.
F Switch on the ignition within ten seconds.
The alarm is disarmed.
Malfunction
When the ignition is switched on, if the red LED
remains on for ten seconds there is a fault in
the siren connection.
Contact a CITROËN dealer to have the system
checked.
Automatic setting of the alarm
Depending on the country in which the vehicle is
sold, the alarm is set automatically approximately
2 minutes after the last door is closed.
To prevent triggering of the alarm when a door
is opened, you must first press the unlocking
button on the remote control again.
Do not make any modifications to the
alarm system as this could cause faults.
Windows, rear
F To open the rear windows, tilt the lever, then
push it all the way to lock the windows in the
open position.
https://www.automotive-manuals.net/
Electric windows
Manual mode
Press or pull the control gently, without going
past the point of resistance. The window stops
as soon as the control is released.
Automatic mode
This operating mode is available on the
driver's side, depending on the version.
This operating mode is available on
the driver's side and on the passenger
side.
Press or pull the control beyond the point
of resistance. The window opens or closes
fully when the control is released. Pressing
the switch again stops the movement of the
window.
Access
2
35