CITROEN BERLINGO MULTISPACE Handbook page 21

F Press the trip distance recorder reset button
and keep it pressed,
F switch on the ignition.
The distance recorder display begins a
countdown.
When the display indicates "=0", release the
button; the spanner disappears.
Following this operation, if you wish to
disconnect the battery, lock the vehicle
and wait at least five minutes for the reset
to be taken into account.
Engine oil level indicator
Depending on your vehicle's engine, when the
ignition is switched on, the engine oil level is
indicated for a few seconds after the service
information.
Oil level correct
Low oil level
The flashing OIL together with the service
indicator lamp, accompanied by an audible
signal and a message on the screen, indicates
a low oil level which could damage the engine.
If the low oil level is confirmed by checking the
dipstick, the level must be topped up.
Oil level gauge fault
The flashing OIL-- indicates a malfunction of
the engine oil level gauge. Contact a CITROËN
dealer or a qualified workshop.
The level read will only be correct if the
vehicle is on level ground and the engine
has been stopped for more than thirty
minutes.
For more information on Checking the
levels and, in particular, the oil level, refer
to the corresponding section.
https://www.automotive-manuals.net/
Trip recorder reset
button
F With the ignition on, press
the button until zeros
appear.
Fuel gauge
The fuel level is tested every time the ignition is
turned to the "on" position.
The gauge is positioned on:
- 1: the tank is full, about 60 litres.
- 0: the use of the reserve is started, the
warning lamp lights up permanently. When
the warning lamp comes on, the reserve is
approximately 8 litres.
Instruments
1
19