In the event of a breakdown
Ensure that the jack is stable. The foot
of the jack must be in contact with the
ground and directly below the jacking
point used.
If the ground is slippery or loose, the jack
may slip or drop – Risk of injury!
Ensure that the jack is positioned only at
one of jacking points under the vehicle,
making sure that the vehicle's contact
surface is centred on the head of the
jack.
Otherwise, there is a risk of damage to
the vehicle and/or of the jack collapsing –
Risk of injury!
Do not extend the jack until you have
started unscrewing the bolts on the wheel
to be changed and have placed the chock
under the wheel diagonally opposite.
146
Fitting the spare wheel
When using a non-uniform spare wheel,
do not exceed 50 mph (80 km/h).
The spare wheel is not designed to
be used over long distances. Have
the tightening of the bolts and the tyre
pressure of the spare wheel checked by a
CITROËN dealer or a qualified workshop
as soon as possible.
Also, have the original wheel repaired
and refitted by a CITROËN dealer or a
qualified workshop as soon as possible.
F Position the wheel on the hub and start
tightening the bolts by hand.
https://www.automotive-manuals.net/
F Carry out an initial tightening of the bolts
using the wheelbrace.
F Lower the vehicle completely by folding the
jack, then remove the jack.
F Tighten the wheel bolts again using the
wheelbrace; tighten them fully without
forcing them.
F Place the wheel to be repaired in the carrier.
Need help?
Do you have a question about the BERLINGO MULTISPACE and is the answer not in the manual?