Schletter FixZ-7 Mounting Instructions

FixZ-7
Mounting Instructions
Middle clamp
Fastener (Fix2000 KlickTop)
Required tools
Screwdriver with bits:
Bit T40
Bit hex-head SW6
Corresponding tools
for the selected fasteners
The Schletter tool kit comprises
tools required for all standard
systems.
Safety instructions
Planning, mounting and start-up of the solar plant must be performed by qualifi ed personnel only. Poor quality execution can
result in damage to the plant and to the building and can present a risk to people.
Risk of falling! There is a risk of falling when working on the roof as well as when ascending and descending the building. Accident
prevention regulations must be observed and appropriate safety equipment must be used.
Risk of injury! Objects falling from the roof can hurt or even kill people. The danger area around the installation site must be sealed
off and people close to this area must be warned.
Risk of breakage! PV modules can be damaged if stepped upon.
Risk of electric shock! The mounting and maintenance of the PV modules must be carried out by qualifi ed
personnel only. Please observe the all safety regulations issued by the manufacturer!
© Schletter GmbH Gewerbegebiet an der B15
•
Fax: +49 8072 9191-9200 E-mail: solar@schletter.eu
•
Your contact in the UK: Schletter UK Limited, Tel.: +44 1296 461 800, Fax: +44 1296 461 801, E-mail: info@schletter.co.uk
FixZ-7 Mounting Instructions
End clamp
Additional documentation
Structural analysis
Analysis print-out with schematic diagram
from the plant calculation
Alustraße 1 83527 Kirchdorf/Haag i. OB
• •
www.schletter.eu Updated 08/2012
• •
System rail upper
System rail lower
Germany Tel.: +49 8072 9191-200
• •
Subject to change without notice
•
EN
1