Advertisement
LaQ07 Framed
Mounting Instructions
Required tools
Screwdriver with bits:
Bit hex-head SW6
Bit 6-Lobe T40
Flat wrench / spanner SW15
Corresponding tools
For the selected fasteners
The Schletter tool kit
comprises tools required for all
standard systems.
Safety instructions
Planning, mounting and start-up of the solar plant must be carried out exclusively by qualified specialists. Poor quality execution
can result in damage to the plant and to the building and can present a risk to people.
Risk of falling! There is a risk of falling when working on the roof as well as when ascending and descending the building.
Accident prevention regulations must be observed and appropriate safety equipment must be in place.
Risk of injury! Objects falling from the roof can cause injury to people. The danger area around the installation site must be
secured and people present in the area warned of the risks.
Risk of breakage! PV modules can be damaged if stepped upon.
Risk of electric shock! The mounting and maintenance of the PV modules must be carried out exclusively by qualified specialists.
Please observe all safety regulations issued by the manufacturer!
© Schletter GmbH
Gewerbegebiet an der B15
•
Fax: +49 8072 9191-9200
E-mail: solar@schletter.eu
•
Your contact in the UK: Schletter UK Limited, Tel.: +44 1296 461 800, Fax: +44 1296 461 801, E-mail: info@schletter.co.uk
LaQ07 Framed - Mounting Instructions
Middle clamp
Additional documentation
Structural analysis
Analysis print-out with schematic diagram
from the plant calculation
Alustraße 1
83527 Kirchdorf/Haag i. OB
•
•
www.schletter.eu
Updated 08/2012
•
•
End clamp
Module bearing
Germany
Tel.: +49 8072 9191-200
•
•
Subject to change without notice
•
Bearing plate
Fastener (Fix2000 Standard)
profile
GB
1
Advertisement
