Fluke 5730A Calibration Manual page 48

5730A
Calibration Manual
1. Touch Setup Menu>Calibration>Range Adjustment >DCV to show the
2. Touch 220 V and enter the nominal value.
3. Connect the 732B, 8508A, and 752B in a 10:1 configuration, as shown in
4. Multiply the 732B value by 10, and enter this new value. The Product output
5. Push  to show this display and confirm the values:
6. Push to activate the Product output.
7. Turn the output adjustment knob on the Product until a null is achieved on the
8. Touch Save to store the results and adjust the Product. If the security
38
Range Adjustment menu.
Figure 3.
will be nulled to this new value.
Setup Menu Calibration
220 V
Standby
Press OPERATE. Adjust with knob then press Continue.
200.00000
Reference
200.000000 dBm
External External External
Sense Sense
OFF OFF
null detector, and then touch Continue.
passcode has not already been entered, the Product prompts to do so before
the results are saved. Touch Discard to remove the results from the
calibration.
Range
Adjustment
Guard
OFF
V
Error
= +0.00ppm
Continue
hhp217.eps